Installation Instructions
CALCULATE THE DUCT RUN LENGTH
The duct run should not exceed 35 feet if ducted six inch (6”) round ductwork. Calculate the length of the ductwork by adding the equivalent feet in fig. 06 for each piece of duct in the system an example is given in fig. 07. For best results, use no more than three 900 elbows. Make sure that there is a minimum of 24” of straight duct between elbows if more than one is used. Do not install two
elbows together.
FIG.06 |
| FIG.07 |
| |
45° Elbow = | 5.0 feet | 9 | Feet Straight Duct | 9.0 feet |
90° Elbow = | 7.0 feet | 2 | - 90° Elbows = | 14.0 feet |
90° Flat Elbow | 12.0 feet | Wall Cap | 0.0 feet | |
Wall Cap | 0.0 feet | Total System = | 23.0 feet | |
WARNING: Personal injury hazard due to the weight and size of the euro hood canopy, two or more people are needed to move and safely install the euro hood canopy. Failure to properly lift euro hood could result in damage to the product or personal injury.
WALL PREPARATION
WARNING: The screws provided for mounting this euro hood must be inserted into solid wood. These must not be inserted into sheet rock.
1)Disconnect and move freestanding range from cabinet opening to provide easier access to upper cabinet and rear wall. Put a thick, protective covering over cooktop,
2)Determine and clearly mark with a pencil the centerline on the wall where the euro hood will be installed.
3)The euro hood attaches to the wall by mounting screws. For the 30" and 36" models, there are two mounting screws. Install the screws into the wall. The screws should be inserted into the wall until the screw head is flush with the wall.
4)The optional chimney kit is adjustable and designed to meet varying ceiling heights. The chimney attaches to the wall by two additional brackets. The top bracket should be installed about 1/8” away from the ceiling. The middle bracket must be installed at the bottom point of the upper chimney sleeve. Determine the proper location for each bracket and install the brackets on the wall. Attach the bottom of the lower chimney to the canopy using the screws provided.
CAUTION: Make sure that the screws and brackets are securely fastened to the wall.
9
