DCS Flat Panel TV warranty Mounting the display, Display Adjustments Roll Control

Mounting the display

1.Locate the set of four 3/8”-16 button head cap screws removed at the beginning of the installation.

2.Thread two of the screws approximately a 1/4”(0.6cm) into the upper set of PEM nuts on the adaptor plate, as shown

3.With the help of an assistant, carefully lift the display and hang it onto the P-150 by dropping the exposed portion of the screws down into the

key slots on the nose piece of the P-150.

4.With the display hanging on the mount, thread the second set of screw into place, and then tighten all four screws securely.

Display Adjustments

Roll Control

Function – Horizontal leveling of the display.

Operation – Grasp the sides of the display, and roll it into the desired position.

Adjusting Roll Tension – Roll tension is controlled by the two tension bolts located on the outer edges of the nose piece. Use an open-ended 9/16” wrench to make adjustments to the tension bolts by inserting wrench between the nose piece and the adaptor plate.