DCS Flat Panel TV Vertical Tilt, Swivel, 180¡Pan, Stowing the screen, Centering the Screen

Vertical Tilt

Function – raising and lowering the screen edge to improve viewing angle/picture quality.

Operation – Loosen tilt tension screws with supplied 3/16” Hex wrench as shown. Adjust display for desired tilt angle. Re-tighten tension screws.

CAUTION :

It is important to try to maintain even torque on each of the 4 screws.

Swivel

Purpose – Optimize viewing angle for off center viewing positions. Operation – Grasp edges of display and swivel into desired position.

Adjust swivel tension – Adjust tension with supplied 3/16” Hex wrench.

180¡Pan

Purpose – Allows display to be positioned perpendicular to wall.

Operation – Extend cantilever arm completely. Fully swivel display in desired direction.

Note: Maximum screen size for full 180¡Pan is approximately 50.

Stowing the screen

Purpose – Allows display to be folded flat to the wall.

Operation – Grasp center pivot point of cantilever arm and edge of display. Fold arm in half at pivot point and push display back flat against wall.

Centering the Screen

The screen will be centered with the cantilever arm folded in one direction only, as shown.