Assembly Instructions
NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly is the responsibility of the installer.
STEP 1 | FIG.01 |
Remove all individual components from all cartons. Dispose of the remaining packaging.
STEP 2
Remove one protective end cap from the intake pipe, make certain pipe threads remain wrapped with white teflon tape.
• Do not tape over the first two threads at the of the intake pipe (fig. 01)
STEP 3
Locate the heater head assembly. Place the head assembly on a stable horizontal surface. Please allow for the entire length of the patio heater when establishing a work area (i.e. workbench, floor). Remove valve panel by removing the knob then the (4) screws. Be careful when removing valve panel so as not to tug on igniter wire that is still attached. Carefully remove wire, (attached with a push/pull connection).
Firmly holding the safety valve with channel lock pliers, thread the intake pipe clockwise into safety valve until tight. Reattach the valve panel and continue to step 4 to attach the post assembly.
FIG.02
Match
Light Cover
5
