Troubleshooting
| PROBLEM: | Is there adequate | |
| Burner flame is | ||
gas supply? | ||
low. | ||
| ||
|
|
Is the supply hose bent or kinked?
YES
Straighten hose
Check the burner and orifices for
blockage, see page 15
| Fill LP cylinder |
| NO |
|
|
|
YES
|
|
| NO |
|
|
|
|
|
|
|
|
|
|
|
|
| Is the control knob in the full “on” | ||
|
| position? (all the way counter | ||
YES |
|
| clockwise)? | |
|
|
|
| |
|
|
|
|
|
PROBLEM:
Emitter glow is
uneven.
Is the heater level?
YES
Is there adequate
gas supply?
YES
Is the lower screen cone tilted?
Note: It is normal for the bottom 1/2” to 1” of the emitter not to glow. In addition, the section of the emitter above the valve panel may also glow less than the rest of the emitter.
NO |
| Fill LP cylinder |
|
|
|
NO |
| Level heater |
|
|
|
YES |
| Loosen but don’t remove screws at top of |
| safety valve cylinder, level, retighten | |
|
|
NO |
| Clean burner |
| see page 15. | |
|
|
18
