Euro-Pro VPW41H Safety & Warning Instructions, Trouble Shooting, Danger, Problem, Possible Reason

Models: VPW41H

1 6
Download 6 pages 13.26 Kb
Page 3
Image 3
TROUBLE SHOOTING
WARNING
Risk of injection or severe injury. Keep clear of nozzle. Do not discharge streams at persons. This product is to be used only by trained operators. Always remove lance from gun before cleaning debris from tip.
• Keep clear of nozzle. NEVER direct high pressure spray at any person, animal or self.
• Always wear safety goggles or glasses and protective clothing when operating, performing maintenance or changing accessories.
Never put hands or fingers over the spray tip while operating the unit.
Never try to stop or deflect leaks with any body part.
• Always engage the trigger safety latch in the safe position when spraying is stopped even if only for a few minutes.
• Always follow detergent manufacturer's label recommendations for proper use of detergents. Always protect eyes, skin and respiratory system from detergent use.
WARNING
SERVICING OF A DOUBLE-INSULATED APPLIANCE.
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means are provided for a double-insulated product, nor should grounding means be added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system and should be done only by qualified service personnel. Replacement parts for a double- insulated product must be identical to the original parts. A double-insulated
product is marked with the words " double Insulation" or "Double Insulated". Product may also be marked with symbol shown.
9. Keep operation area clear of all persons.
10. Do not overreach or stand on unstable support. Keep good footing and balance at all times.
11. Follow maintenance instructions specified in this manual.
12. This product shall be connected to a power supply receptacle protected by a ground fault circuit interrupter (GFCI) (electric power washers only).
13. If product is provided with a GFCI, be sure to inspect the cord and GFCI prior to use. Any repair or replacement of the power cord must be performed by a qualified (licensed or certified) electrical technician.

TROUBLE SHOOTING

PROBLEM

 

POSSIBLE REASON
POSSIBLE SOLUTION

 

 

 

 

 

 

1.

Electrical socket is

1.

Check plug, socket, fuses,

PRESSURE WASHER

 

faulty or breaker has

 

breaker.

 

tripped.

2.

Check that the voltage is

WILL NOT START WHEN

 

2.

Voltage is inadequate.

 

adequate.

THE ON/OFF SWITCH IS

 

3.

GFCI has tripped.

3.

Reset/Try another electrical

IN THE "ON" POSITION

4.

Power cord is not

 

outlet.

 

 

plugged in.

4.

Plug in power cord.

 

 

 

 

 

 

1.

Water intake filter is

1.

Remove and clean water

 

 

intake filter.

 

 

clogged.

 

 

 

2.

Tighten connections/bleed

PUMP DOESN'T REACH

2.

Pump is drawing air.

 

system.

ADEQUATE PRESSURE

3.

Diameter of garden

 

3.

Replace with 3/4 inch

OR CAVITATES

 

hose is too small.

 

 

garden hose.

 

4.

Water supply is

 

 

4.

Check hose for kinks or

 

 

restricted.

 

 

 

leaks, open tap fully.

 

 

 

 

 

 

 

 

 

 

 

 

1.

Turn unit and water supply

 

1.

Excessive air in

 

off/Bleed system/Hold

PRESSURE WASHER

 

trigger down. Allow water to

 

waterline and pump.

 

HAS OR WILL NOT

 

 

flow through the pump for

2.

Water supply is

 

MAINTAIN PRESSURE

 

30 seconds.

 

restricted.

 

 

 

2.

Check hose for kinks or

 

 

 

 

 

 

 

leaks, open tap fully.

 

 

 

 

 

PRESSURE WASHER

1.

Air intake is blocked.

1.

Clean the air intake vents.

MAKES EXCESSIVE

2.

Water intake filter is

2.

Check & clean filter.

NOISE

 

dirty.

 

 

 

 

 

 

 

 

MOTOR DOES NOT RUN

 

 

 

 

CONTINUOUSLY WHEN

 

 

 

 

TRIGGER IS SQUEEZED/

1.

Net voltage is lower

1.

Check that the voltage is

MOTOR BUZZES WHEN

TURNED ON BUT DOES

 

than suggested.

 

adequate.

NOT START/MOTOR

 

 

 

 

STOPS RUNNING WHILE

 

 

 

 

UNIT IS IN USE

 

 

 

 

 

 

 

 

 

8

SAFETY & WARNING INSTRUCTIONS

For safety reasons, it is recommended that you read this manual before attempting to operate this appliance. Failure to follow these instructions can result in personal injury or equipment problems. To help recognize note the following symbols:

DANGER

Danger indicates an imminently hazardous situation, which, if not avoided, WILL result in death or serious injury.

WARNING

Warning indicates a potentially hazardous situation, which, if not avoided, COULD result in death or serious injury.

CAUTION

Caution indicates a potentially hazardous situation, which, if not avoided, MAY result in death or serious injury.

NOTE: Information that requires special attention.

Important Safety Instructions SAVE THESE

INSTRUCITONS

When using this product, basic precautions should always be followed, including the following:

DANGER

1. Read all instructions before using the product.

2. To reduce the risk of injury, close supervision is necessary when this product is used near children.

3.Always disconnect power (electric units) before disassembling, repairing or

changing attachments on the unit.

4. Follow all safety codes as well as the Occupational Safety and Health Act (OSHA).

5. Ensure safety devices are operating properly before each use. DO NOT remove or modify any part of the gun or unit.

6. Know how to stop this unit and relieve pressure quickly. Be thoroughly familiar with the controls.

7. Stay alert - Watch what you are doing.

8. Do not operate this unit when fatigued or under the influence of alcohol or drugs.

Rev. 01/05

1

Page 3
Image 3
Euro-Pro VPW41H Safety & Warning Instructions, Trouble Shooting, Danger, Problem, Possible Reason, Possible Solution