Definitive Technology Unpacking Your BP7002/BP7004/BP7006s, Please Inspect For Shipping Damage

Instructions:

1.Carefully lay the speaker on its front surface.

2.Place one of the stabilizer brackets in the rear slot provided. (Note: Stabilizer bracket will be flush with bottom of base.)

3.Insert two screws provided and tighten them securely, being careful not to strip out material.

4.Repeat steps #2 and #3 for the other stabilizer bracket.

5.Remove the supporting feet closest to the stabilizer brackets and thread them into the brass insert in the stabilizer brackets.

6.Carefully return the speaker to the upright position and adjust the glides (supporting feet) to level the speaker.

Note: If desired, the four glides (support feet) may be replaced and the four spikes provided may be installed. The four spikes or glides must be fully threaded into the brass inserts on the stabilizer brackets.

AVERTISSEMENT: Mesures de Sécurité Importantes

Pour réduire les risques que le produit se renverse par inadvertance, quatre supports stabiliseurs avec vis de montage ont été fournis. Ceux-ci doivent être installés sur la base du produit, dans les rainures appropriées.

Procédures d’installation:

Outils requis: Tournevis étoile (non fourni)

Pièces requises: Deux supports stabiliseurs (fournis), quatre vis (fournies)

Instructions:

1.Coucher soigneusement le haut-parleur sur la face avant.

2.Placer un des supports stabiliseurs dans la rainure appropriée arrière. (Note: le support stabiliseur sera égal au bas de la base)

3.Insérer deux des vis prévues à cet effet et serrer de façon ajustée en prenant garde de ne pas élimer les parois du matériel.

4.Répéter les étapes #2 et #3 pour l’autre support stabiliseur.

5.Retirer les niveleurs (pieds de support) les plus rapprochés des supports stabiliseurs et visser les niveleurs, dans l’encolure de cuivre des supports stabiliseurs.

6.Relever soigneusement le haut-parleur dans sa position fonctionnelle et ajuster les niveleurs (pieds de support) pour égaliser le haut-parleur.

Note: Les quatres niveleurs (pieds de support) peuvent être remplacés, si désiré, par les quatres pointes fournies à cet effet.

Unpacking Your BP7002/BP7004/BP7006s

Please Inspect For Shipping Damage

Each loudspeaker leaves our plant in perfect condition. Any visible or concealed damage most likely occurred in handling after it left our plant and should be reported at once to your Definitive dealer or the delivery company that delivered your loudspeaker. Please unpack your system carefully. Save all cartons and packing materials in case you move or need to ship your system. Record the serial number found on the back of the BP7002/BP7004/BP7006 in the appropriate place on your warranty card, answer all questions and send it in.

Positioning the Speakers in Your Room

It is important, because of the BP7002/BP7004/BP7006’s unique bipolar (front and rear) radiation pattern, that some simple set-up recommendations be followed in order to assure optimum performance in your room. Please remember that although these recommendations are usually valid, all rooms and listening set-ups are somewhat unique, so do not be afraid to experiment with the speakers. Remember, whatever sounds best to you is correct.

3