Installation Procedure Overview (continued)
•The speaker enclosure needs to be against joists or framing material on the 2 parallel sides that are to be fastened with the screws.
•The clearance required on outside ceiling surface is 1" around the cutout to clear the speaker bezel. On inside surface, 11/4" of clearance is required to clear lock arms on the sides that will not be fastened to the joists or framing material.
•Also note that the installation of the RCS II may require some modification of the joist structure in your ceiling. This should only be done by a compe- tent professional who will configure the studs to maintain their structural integrity and make sure that everything is in compliance with all local and state building code requirements.
•Speaker wire must be run inside your ceiling as part of the installation process of
Step-by-Step Installation
Mounting options overview
•Installation of this product must follow all local and state building codes.
•We strongly recommend using a qualified, professional installer who is knowledgeable of local building codes.
Required cutout and cavity size
•Template cutout size: 143/8"W x 143/8"L.
•Minimum size of installation cavity (inside ceiling and between joists) is as follows:
–Depth: 57/8"
–141/2" between joists on the sides the wood screws are to be installed in.
–161/2" between joists on sides the lock arms are to be used (11/4" of space required on each side to clear lock arms).
See Diagram 1, page 9 for reference.
5