Gas installation

The necessary installation including gas and electrical connections must be carried out by qualified personnel in accordance with current and local regulations, since an installation by an unqualified person may constitute a hazard.

The manufacturer declines liability for injury to persons or damage caused due to non compliance with these provisions.

The accessories shown below are not supplied and must be acquired by the consumer.

LPG cylinder with plastic hose

Regulator

Flexible

hose LPG cylinder

This appliance uses LPG ( Liquid petroleum or bottle gas)

This appliance requires an operating pressure of 2.75 kPa at the appliance. A suitable LPG regulator that complies with the requirements of SANS 1237 must be used.

The manufacturer and the seller do not accept responsibility for any damage due to incorrect installation or gas connection.

•Gas bottles should be located outdoors in a suitable ventilated lock-up.

•The connecting hose should not exceed 125 cm in length.

•Soak the end of the plastic hose in hot water to soften it and then push the hose end fully over the hose nozzle. ( see sketch 1 above)

•Secure the hose by tightening the hose clamp. ( See sketch 2 above )

•In a similar fashion, secure the other end of the hose to the regulator on the gas bottle. (See sketch 3 above)

PAGE 5 OF16