Safety compliance with local requirements.

Installer’s details are to be filled in on page 16 of this book

Permanent installation. Important information for the user.

The appliance may only be installed by a registered LP Gas installer. All registered installers are issued with a card carrying their registration number. Ask to be shown this card before allowing the installation to commence and make a note of the installer QCC number on page 16 of this book. Upon completion of the installation, the installer is required to explain the operational details of the appliance together with the safety instructions. You will be asked to sign acceptance of the installation and be provided with a completion certificate. You should only sign for acceptance when the installation is completed to your satisfaction.

Failure to comply with the above will render the warranty invalid.

Note: Your invoice is required in the event of you wishing to make a warranty claim.

Important information for the installer.

This appliance may only be installed by a LP Gas installer registered with the LPGSASA. (Liquid Petroleum Gas Association of Southern Africa) . The appliance must be installed in accordance with the requirements of SANS 10087-1 and any fire department regulations and/or local bylaws applicable to the area. If in doubt check with the relevant authority before undertaking the installation. Upon completion of the installation you are required to fully explain and demonstrate to the user the operational details and safety practices applicable to the appliance and installation including:

a)The position of the isolation or shut-off valve in the gas supply line to the appliance.

b)The requirements for safe operation of the appliance

Note.This appliance is supplied ex-factory with jets and air settings for use with LP gas only.

Note: A stove without a flame failure device may only be used with a free standing cylinder placed adjacent to but not closer than 300 mm to the stove.

Check for gas leaks

•Check for gas leaks after installation and whenever a new or re-filled gas bottle is used for the first time.

•Never use a naked flame to check for gas leaks

•Ensure that the control knobs on the hob are in the OFF position.

•Open the valve on the Gas bottle.

•Using a small paint brush, apply some soapy water to all the connections.

•If there is a leak, bubbles will appear.

•If this happens, close the valve on the gas bottle.

•Check and tighten the connections immediately.

•Repeat the procedure to ensure that there are no further leaks.

PAGE 6 OF16