Installation.
Note:The extractor hood is intended to hang from a horizontal ceiling capable of supporting the weight of the hood. (approximately 40 kg)
Step 1
CEILING
1
•Carefully unpack the extractor hood and component parts.
•With the assistance of a qualified in- staller, mount the top extension adaptor to the ceiling above the cooking surface.
•Cut a hole in the ceiling (where applica- ble) to accept a power supply cord with a fitted plug and an outlet pipe
Step 2
•Fit and secure the square tubes into the four recesses on the extractor hood, as shown, using the M8 bolts supplied.
Step 3
•Slide the lower chimney duct onto the extractor hood as shown.
•Slide the top chimney duct ( the one with the louvers) into the lower chim- ney duct.
Step 4
•Remove the grease filters and lift the extractor hood assembly and slot it into the top extension adaptor.
•Adjust to a suitable height.
(minimum 750mm above the cooking surface).
•Tighten the clamping bolts to hold the extractor in place.
•Connect the outlet pipe if required and insert the fitted plug into the 15A socket.
Step 5
•Slide the upper chimney duct into place against the ceiling.
•Fasten from the side.
•Fasten the lower chimney duct to the extractor hood from underneath the ex- tractor as shown.
•Replace the grease filters.
3 X M8 BOLTS ON EACH SIDE
2
3
4
5
CLAMPING BOLTS
2 SELF TAPPING SCREWS
4 SELF TAPPING SCREWS
Page 4
