Repositioning the Freezer door
1 | Insert the water tube into the bottom hinge pin hole. |
| Lower the freezer door bottom hinge hole over the bottom |
| hinge pin and close the door. |
2 | Slide the back of the top hinge into the slot and lower the |
| hinge pin into the top hinge hole of the door. |
3 | Tighten the hinge fastener and |
| ness and earth wire. |
4
5
Snap the hinge cover in place and tighten the screw.
Push the water tube into the coupling.
Repositioning the Fridge door
To replace the refrigerator door, repeat the sequenceas described above noting that there are no water connections and install the bottom plinth.
Installation
•The appliance should be positioned in a dry, well aired place away from heat sources such as stoves, geysers and direct sunlight.
•Allow an airspace of at least 100mm at the sides and rear of the refrigerator for ventilation pur- poses.
•A dedicated cold water tap ( to supply water to the ice dispenser) and an electrical wall socket should be nearby and accessible.
Electrical Installation
•This appliance uses a
•This appliance must be plugged into a dedicated 15A earthed wall socket.
•Do not use an extension cord or multiple adaptor.
•If the power cord is damaged, it must be replaced by a qualified electrician.
•This appliance must be earthed and the manufacturer and the seller do not accept responsibility for any damage due to incorrect electrical connection.
•This appliance may not be used with a battery inverter power supply.
Accessories supplied.
•An egg caddy,
•Filter box, & water supply kit
•Owner’s manual.
Page 3
