Water requirements
Please Note:
•The ice maker requires a minimum water pressure of 3kg/cm². If a 180cm² cup can be filled within 10 sec- onds, the water pressure is sufficient.
•Should the water pressure be too low, an additional pressure pump may be installed by a qualified plumber.
•The water tube must be connected to a threaded cold water tap.
•Ensure that the water tubes are installed away from any hot surfaces such as stoves or heaters.
•Use sealing tape on every pipe/tube connection to en- sure a leak free installation.
Water Supply Kit.
Check that all the parts below have been
supplied.
Any additional parts which may be re- quired may be purchased from your local hardware store.
Water installation
Connecting to the cold water tap.
•Switch off the water supply at the mains.
•Check that B and C are fitted with rubber washers.
•Fit connector C to the cold water tap.
•If connector C does not fit the tap, use connector B. If neither fits, consult your plumber.
•Connect B to C.
•Insert water tube into connector A and join to B
Installing the filter
•The water filter is designed to filter out contaminants but does not filter out bacteria or microbes.
•Install the filter along the water tube and where it will be easily accessible for routine maintenance.
•The water tube must be cut at a right angle at the filter location point.
•Connect the water tubes to the filter as shown leaving sufficient slack so as not to strain the joins.
•Tighten all the joints, open the tap and ensure that there are no leaks.
•The filter life depends on the amount of use and pollut- ant present in the water. It is recommended that the filter be replaced every six months.
•After the installation of the refrigerator and water supply tubes, select and continue pressing WATER on the con- trol panel for 2 to 3 minutes to fill the water storage tank in the refrigerator.
Rubber washers
Rubber washer
Page 4
