Back to Contents Page
Display Assembly
Dell™Inspiron™1300/B120/B130ServiceManual
Removing the Display Assembly
Removing the Display Bezel
Removing the Display Panel
Installing the Display Panel

Removing the Display Assembly

1. Follow the instructions in Before Working Inside Your Computer.
2. Remove the hinge cover. See Removing the Hinge Cover.
3. Remove the keyboard. See Removing the Keyboard.
4. Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.
5. Disconnect the antenna cable.
6. Close the display.
7. Turn the computer upside down with the back of the computer facing you.
8. From the bottom of the computer, remove the two M2.5 x 8-mm screws labeled "D."
9. From the back of the computer, remove the two M2.5 x 8-mm screws labeled "D."
10. Turn the computer right-side up and open the display.
11. Carefully remove the antenna cable and the display cables from their routing guides.
CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.