ASSEMBLY
Make Assembly Easier
Everything in this manual is designed to ensure that the resistance system can be assembled successfully by almost anyone. By setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two persons.
•Because of its weight and size, the resistance system should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the resistance system as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the resistance system, make sure that all parts are oriented as shown in the drawings.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
The included hex keys 
and the following tools (not included) may be required for assembly:
• two adjustable wrenches
• one Phillips screwdriver
Assembly will be more convenient if you have a socket set, a set of
1. | 1 | |
Before beginning assembly, make sure | ||
that you understand the information in |
| |
the box above. For help identifying small |
| |
parts, see the PART IDENTIFICATION |
| |
CHART on page 5. |
| |
Insert the two Base Legs (2) into the Base (1) |
| |
as far as possible. With the help of a second |
| |
person, carefully tip the resistance system onto |
| |
its left or right side. |
| |
Attach one of the Base Legs (2) to the Base (1) | 2 | |
| ||
with two M10 x 20mm Button Screws (59); do |
| |
not tighten the Button Screws yet. | 77 | |
Attach the Left Base Cover (20) to the Base (1) | 63 | |
with an M4 x 12mm | ||
20 | ||
and an M5 Large Washer (63). | ||
| ||
Repeat this step on the other side of the | 1 | |
59 | ||
resistance system. | ||
| 2 | |
| 6 |
