Installing the Optical Drive Connector
1.Tighten the screws to secure the optical drive connector to the computer.
2.Install the:
a.palmrest assembly
b.keyboard
c.memory module
d.hard drive
e.WLAN card
f.access panel
g.optical
h.battery
3.Follow the procedures in After Working Inside Your computer.
Removing the Input/Output (I/0) Board
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove:
a.Battery
b.optical
c.access panel
d.hard drive
e.memory module
f.keyboard
g.palmrest assembly
3.Perform the following steps as shown in the illustration:
a.Lift the locking tab [1].
b.Disconnect the I/O board cable from the computer [2].
c.Lift the I/O board partially to a
22