Back to Contents Page
IEEE 1394 Module
Dell™ Studio XPS™ 1640 Service Manual
Removing the IEEE 1394 Module
Replacing the IEEE 1394 Module
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the computer.
Removing the IEEE 1394 Module
1.Follow the instructions in Before You Begin.
2.Remove the palm rest (see Removing the Palm Rest).
3.Remove the screw that secures the IEEE 1394 module.
4.Disconnect the module cable from the system board connector.
5.Lift the module out of the computer base.
1 | IEEE 1394 module cable connector | 2 | IEEE 1394 module |
|
3 | screw |
|
|
|
|
|
|
|
|
|
|
|
|
|
Replacing the IEEE 1394 Module
1.Place IEEE 1394 module in the computer base.
2.Replace the screw that secures the module.
3.Connect the module cable to the system board connector.
4.Replace the palm rest (see Replacing the Palm Rest).
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.
Back to Contents Page
