Dell 1721 manual Removing the Palm Rest Replacing the Palm Rest

Back to Contents Page

Palm Rest

Dell™ Vostro™ 1700 and Inspiron™ 1720/1721 Service Manual

Removing the Palm Rest

Replacing the Palm Rest

Removing the Palm Rest

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.

1.Follow the instructions in Before You Begin.

2.Remove the optical drive (see Removing the Optical Drive).

3.Remove the hard drive (see Removing a Hard Drive).

4.Remove the hinge cover (see Removing the Hinge Cover).

5.Remove the keyboard (see Removing the Keyboard).

6.Remove the display assembly (see Removing the Display Assembly).

7.Remove the internal card with Bluetooth wireless technology, if installed (see Removing the Bluetooth Card).

NOTE: It is not necessary to remove the Bluetooth cable connector from the system board connector.

8.Remove the sixteen M2.5 x 8-mm screws from the bottom of the computer.

NOTE: The screw locations may vary slightly from the image shown below.

9. Turn the computer over and remove the six M2.0 x 3-mm screws that secure the top of the palm rest.

10. Disconnect the touch pad connector from the system board.