Dell 2400 manual Installing the PowerEdge System in the Rack, Installing the Rack Adapters

Installing the PowerEdge System in the Rack

The subsections that follow include instructions for installing the PowerEdge system.

Installing the Rack Adapters

To install the rack adapters on the computer, perform the following steps.

The following procedure is required only if you are converting a PowerEdge 2400 system from a tower chassis to a rack-ready chassis.

CAUTION: The computer may weigh up to 32 kg (70 lb) when fully loaded. To prevent personal injury, do not attempt to move the computer by yourself.

1.Lay the computer on its top side (see Figure 1-9) on a piece of foam or cardboard (to prevent damage to the computer while you remove the feet).

back of computer

	top side
left side	right side

front of computer

Figure 1-9. Computer Orientation

2.Use a small flat-blade screwdriver to remove the plastic screw from each of the four rubber feet on the bottom of the chassis (see Figure 1-10).

support.dell.com Dell PowerEdge 2400 Systems Rack Installation Guide 1-11