Manuals / Dell / Home Audio / Stereo System

Dell 2400 manual inches 10.5 inches template

Models: 2400

1 32

Download 32 pages 46.72 Kb

Page 21

10.5 inches

6U (10.5 inches) between slide assemblies (drawing is not to scale)

10.5 inches

10.5 inches

template

Figure 1-7. Determining Where to Install the Slide Assemblies

5.Align the mounting tab on the front of the slide-assembly mounting bracket with the notches in the rack (see Figure 1-8).

6.Push until the mounting tabs are secure in the notches on the rack and the pushbutton clicks out.

7.Push back on the slide assembly until the mounting tabs lock into the back side of the rack.

8.Repeat steps 5 through 7 for the other side of the rack.

Ensure that the rails are mounted at the same position on each side of the rack.

support.dell.com

Dell PowerEdge 2400 Systems Rack Installation Guide 1-9

Image 21

Dell 2400 manual inches 10.5 inches template

Contents

Dell PowerEdge 2400 Systems RACK INSTALLATION GUIDENotes, Notices, Cautions, and Warnings Safety Instructions Safety Caution and WarningsNotes, Notices, Cautions, and Warnings General Precautions Additional Safety PrecautionsTo help avoid damaging your system components, be sure the voltage selection switch if provided on the power supply is set to match the power available at your location Precautions for Rack-MountableProducts Precautions for Products With Laser Devices When Working Inside Your Computer Ergonomic Computing Habits Protecting Against Electrostatic DischargePage Contents Index FiguresPage Page cable-managementarm assembly Figure 1-1.Rack Kit Contentsbe installed slide assemblies 1 pair with mounting bracketsBefore You Begin Installing the Rack KitRecommended Tools Removing the Doors From a 24-Uor 42-URackFigure 1-2.Opening the Latch on the 24-URack Door Figure 1-3.Opening the Latch on the 42-URack Door hinge release lever Figure 1-4.Removing the 42-URack DoorsFigure 1-5.Removing the 24-URack Doors Installing the Slide Assemblies in the RackFigure 1-6.One Rack Unit 10.5 inches 10.5 inches template push button slide-assembly mounting-bracketflange Figure 1-8.Installing the Slide Assembliesmounting tabs slide assemblies front of rackInstalling the PowerEdge System in the Rack Installing the Rack AdaptersFigure 1-9.Computer Orientation bottom of chassis Figure 1-10.Removing the FeetFigure 1-11.Removing the Computer’s Top Cover Installing the Computer back latch green middle latch yellow Figure 1-13.Installing the Computer in the RackFigure 1-14.Installing the Cable-ManagementArm Installing the Cable-ManagementArmReplacing the Rack Doors 3.Repeat steps 1 and 2 to install the back door Index installing safety instructionsfor preventing ESD health considerations