Dell 2850 manual 4. LCD Status Messages continued

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

Table 1-4. LCD Status Messages (continued)

Line 1	Line 2	Causes	Corrective Actions
Message	Message
E0780	PROC n PRESENCE	Microprocessor is not installed	Install a microprocessor in
		in socket n.	socket n. See "Replacing a
			Processor" in your Installation
			and Troubleshooting Guide.
E07F0	PROC n IERR	Faulty or improperly installed	See "Troubleshooting the
		microprocessor.	Microprocessors" in your
			Installation and Troubleshooting
			Guide.
E07FA	PROC n THERMTRIP	Specified microprocessor is out	See "Troubleshooting System
		of acceptable temperature range	Cooling Problems" in your
		and has halted operation.	Installation and Troubleshooting
			Guide. If the problem persists,
			ensure that the microprocessor
			heat sinks are properly installed.
			See "Replacing a Processor"
			in your Installation and
			Troubleshooting Guide.
			NOTE: The LCD continues to
			display this message until the
			system’s power cord is
			disconnected and reconnected to
			the AC power source, or the SEL
			is cleared using either Server
			Assistant or the BMC Management
			Utility. See the Dell OpenManage
			Baseboard Management
			Controller User’s Guide for
			information about these utilities.
E0876	PS n MISSING	No power available from the	See "Troubleshooting Redundant
	PS n STATUS	specified power supply; specified	Power Supplies" in your
		power supply is improperly	Installation and Troubleshooting
		installed or faulty.	Guide.
E0876	PS n PREDICTIVE	Power supply voltage is out of	See "Troubleshooting Redundant
		acceptable range; specified power	Power Supplies" in your
		supply is improperly installed or	Installation and Troubleshooting
		faulty.	Guide.
E0876	PS n AC LOST	Power source for specified power	Check the AC power source
	PS n AC RANGE	supply is unavailable, or out of	for the specified power supply.
		acceptable range.

8

Information Update