Dell 340 manual Hard-Drive Replacement

1hard-drive data cable

2power cable

3hard-drive connector (IDE PRI)

5.Press in on the tabs on each side of the bracket, and slide it up and out.

6.If the replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive.

NOTICE: To avoid possibly damaging the drive by ESD, ground yourself by touching an unpainted metal surface on the back of the computer.

NOTICE: When you unpack the drive, do not set it on a hard surface, which may damage the drive. Instead, set the drive on a surface, such as a foam pad, that will sufficiently cushion it.

7.If necessary, attach the bracket rails to the new hard drive by aligning the four screw holes of the drive and bracket and then inserting and tightening the screws that came with your upgrade kit.

8.Reinstall the hard-drive bracket by gently sliding the bracket into place until you hear it securely click.

Hard-Drive Replacement

9.Connect a power cable to the power cable connector on the back of the drive, and connect the hard-drive data cable to the hard-drive data cable connector on the drive.

Hard-Drive Cable Attachment