Global IPv6 address: 1::1/
Global IPv6 address: 2::1/64
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:06:14
Queueing strategy: fifo
Input 791 packets, 62913 bytes, 775 multicast
Received 0 errors, 0 discarded
Output 21 packets, 3300 bytes, 20 multicast
Output 0 errors, 0 invalid protocol
Time since last interface status change: 00:06:03
Unless you configure the management route command, you can only access the Management
interface from the local LAN. To access the Management interface from another LAN, configure the
management route command to point to the Management interface.
A virtual IP is an IP address assigned to the system (not to any management interfaces) and is a
CONFIGURATION mode command. When a virtual IP address is assigned to the system, the management
interface is recognized by the virtual IP address — not by the actual interface IP address assigned to it.
•virtual-ip is a CONFIGURATION mode command.
• Executing the show interfaces and show ip interface brief commands on themanagement
interface displays the virtual IP address and not the actual IP address assigned on that interface.
• The management interface uses only the virtual IP address if it is configured. The system cannot be
accessed through the native IP address of the management interface.
• After the virtual IP address is removed, the system is accessible through the native IP address of the
management interface.
• Primary and secondary management interface IP and virtual IP must be in the same subnet.
To view the Management port, use the show interface Managementethernet command in EXEC
Privilege mode.
Configuring a Management Interface on an Ethernet Port
You can manage the Z9500 from any port.
To configure an IP address for the port, use the following commands. There is no separate management
routing table, so configure all routes in the IP routing table (the ip route command).
• Configure an IP address.
INTERFACE mode
ip address
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Interfaces 407