Installing System Components 97
Figure 3-27. Removing and Installing the System Board
Installing the System Board
1
Align the holes A and B on the system board to position the board correctly
in the system.
2
Replace the ten screws to secure the system board in place.
3
Reconnect the power, IPMB, SATA, front panel, and system board
connectors to the system board. See "System Board Connectors" on
page 115.
4
Replace the processors. See "Installing the Processor" on page61.
5
Replace the heat sinks. See "Installing the Heat Sink" on page 59.
6
Replace the expansion-card riser. See "Installing the Expansion-Card Riser"
on page70.
7
Replace the memory modules. See "Installing Memory Modules" on
page 68.
8
Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 57.
9
Replace the system cover. See "Closing the System" on page56.
10
Reconnect the system and peripherals to their electrical outlets, and turn
on the system.
1 screws (10) 2 system board assembly
1
2
book.book Page 97 Tuesday, February 26, 2013 11:33 AM