Dell C1100 - page 90

90 Installing System Components
6 Disconnect the SATA cables, the IPMB cable, and the power cable.
See Figure5-4.
CAUTION: To prevent damage to the drives and backplane, you must remove the
hard drives from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label
them before removal so that you can replace them in the same locations.
7 Remove all the hard drives. See "Removing a Hard-Drive Carrier" on
page 54.
8 Remove the six screws that secure the backplane. See Figure3-22.
9 Slide the board up and lift the backplane clear of the system.
Figure 3-23. Removing and Installing the Backplane
1 screws (6) 2 expander board
2
1
book.book Page 90 Tuesday, February 26, 2013 11:33 AM