22 Removing and Replacing Parts
www.dell.com | support.dell.com
Removing the Mini-PCI Card Assembly NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the compute r.
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
1Remove the memory module cover.
2To release the mini-PCI card assembly fro m its sock et, sp read a part the
metal securing tabs until the assembly pops up slightly.
3Lift the mini-PCI card assembly out of its socket and disconnect any
attached cables.
Replacing the Mini-PCI Card Assembly NOTICE: The mini-PCI card must be inserted at a 45-degree angle to avoid
damaging the connector.
NOTICE: The mini-PCI card is keyed, o r designed to fit int o its socket, in only
one direction. Do not force the connection.
1Align the mini-PCI card with the socket at a 45-d egree angl e, and pre ss
the mini-PCI card firmly into the socket.
2Depending on the type of mini-PCI card you are installing, either
connect the interface cables to the mini-PCI card, or connect the
mini-coax antenna cable from the mini-PCI card to the internal
antenna.
3Lower the mini-PCI card until it snaps into the metal securing tabs.
NOTE: If you are installing a wireless NIC, fold and tuck the unused
interface cables into the slot so they do not interfere with the cover.
NOTE: A modem-only mini-PCI card has one connector; place the unused
NIC connector under the mini-PCI card.
4Replace the memory module cover.