Dell Computer Drive manual Viewing or Ending an iSCSI Session, Lowest priority default

Table 3-2. Advanced iSCSI Host Port Settings (continued)

Setting	Description
Ethernet Priority	The network priority can be set from lowest to highest.
	Although network managers must determine these
	mappings, the IEEE has made broad recommendations:
	• 0 — lowest priority (default)
	• 1-4 — ranges from "loss eligible" traffic to controlled-load
	applications, such as streaming multimedia and business-
	critical traffic
	• 5-6 — delay-sensitive applications such as interactive
	video and voice
	• 7 — highest priority reserved for network-critical traffic
	(do not use with the MD3000i)
TCP Listening Port	The default Transmission Control Protocol (TCP)
	listening port is 3260.
Jumbo Frames	The maximum transmission units (MTUs). It can be set
	between 1500 and 9000 bytes per frame. If the Jumbo
	Frames are disabled, the default MTU is 1500 bytes per
	frame.

NOTE: Changing any of these settings resets the iSCSI port. I/O is interrupted to any host accessing that port. You can access the I/O automatically after the port restarts and the host logs in again.

Viewing or Ending an iSCSI Session

1Click the iSCSI tab, and then click View/End iSCSI Sessions.

2Select the session you want to view in the Current sessions box. The details are shown below in the Details box.

3If you want to end the session, perform the following steps:

a Select the session that you want to end, and then click End Session to show the End Session confirmation window.

36

Using iSCSI