Dell D610 manual Display Panel, Installing the Display Bezel

Models: D610

1 47
Download 47 pages 28.61 Kb
Page 14
Image 14
Installing the Display Bezel

6. Remove the six M2.5 x 5-mm screws located on the front of the bezel.

1display bezel

2display panel

3display bumpers (6)

4M2.5 x 5-mm screws (6)

NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.

7.Starting at the bottom of the display panel (by the Dell™ logo), use your fingers to separate the bezel from the top cover by lifting the inside edge of the bezel and rotating away from the top cover.

NOTE: Follow the same procedure on all four sides of the display bezel until it snaps completely off.

Installing the Display Bezel

1.Starting at any corner, use your fingers to gently snap the bezel in place securing the display panel.

2.Tighten the six M2.5 x 5-mm screws on the front of the bezel.

3.Replace the six display bumpers around the display assembly.

Display Panel

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

Page 14
Image 14
Dell D610 manual Display Panel, Installing the Display Bezel