Toro 2300-D, 2600D Height±of±Cut and Leveling Rear Roller, 5/8º, Cutting Units, Page 7 ±

Height±of±Cut and Leveling Rear Roller

Note: Both floating and fixed cutting units can use this method for making height of cut adjustments and level- ing both front and back rollers.

1.Position cutting unit on a flat level table or board.

2.Slightly loosen (crack) nut securing each roller bracket to the angle bracket.

3.For the rear roller, adjust support cap screw to achieve 5/8º +1/16 (15.9 mm
1.6) dimension between both Height±of±Cut supports and rear roller brackets.

4.For the front roller, adjust support cap screw to achieve 1º + 1/16 (25.4 mm
1.6) dimension between both Height±of±Cut supports and front roller brackets.

5.For the rear roller, remove hairpin cotters securing rear Height±of±Cut pins and reinstall in the 1/2º setting as indicated on the rear Height±of±Cut plate.

6.For the front roller, remove hairpin cotters securing front Height±of±Cut pins and reinstall in the 1/4º setting as indicated on the front Height±of±Cut plate to allow clearance between front roller and table.

7.Position a 1/2º or thicker bar under the reel blades and against the front face of the bedknife. Make sure bar covers the full length of reel blades.

8.Verify that rear roller is level, by attempting to insert a piece of paper under each end of roller. The paper should not fit between the roller and the table.

9.Level rear roller by adjusting the appropriate sup- port cap screw on rear roller supports until the roller is parallel and the entire length of roller contacts the table. A piece of paper inserted between the roller and the table should not fit.

10.When roller is level, adjust both rollers to desired Height±of±Cut with pins. Tighten nuts securing roller brackets and replace hairpin cotters to the Height of cut pins.

6

5/8º

8

5

4

1º

2

7

1

4

3

Figure 6

1.	Nut	5.	Support capscrew
2.	Rear roller bracket	6.	Height±of±Cut support
3.	Front roller bracket	7.	Height±of±Cut pins
4.	Angle bracket	8.	Height±of Cut plate

Cutting Units Page 7 ± 8 Reelmaster 2300±D/2600±D