Cutting Unit Solenoid Valve Coil
The solenoid valve coil can be easily replaced without opening the hydraulic system.
Removal
1.Disconnect the electrical connector.
2.Remove the nut from the spool assembly.
3.Slide the coil assembly and O±rings from the spool assembly. Discard the coil assembly and O±rings.
4.Clean any corrosion or dirt from the spool assembly.
Installation
1.Coat new O±rings lightly with petroleum jelly. Slide new O±rings and new coil assembly onto the spool as- sembly. Align the coil assembly evenly with the manifold body.
2.Apply Loctite 242 or equivalent to the threads. Screw the nut onto the spool assembly and torque to 15 in±lb (17 KG±CM). Do not over tighten.
3.Connect the electrical connector.
3 |
|
| 1 |
3 | 2 |
| |
| 4 |
Loctite 242 |
|
Figure 26
1. | Nut | 3. | O±ring |
2. | Coil assembly | 4. | Spool assembly |
Electrical System | Page 5 ± 30 | Reelmaster 2300±D/2600±D |
