Toro 2300-D Wheel Motor, Front Wheel Removal Fig, Front Wheel Installation Fig, Hydraulic System

Wheel Motor

Front Wheel Removal (Fig. 30)

1.Before removing any parts from the hydraulic sys- tem, park the machine on a level surface, engage the parking brake, lower the cutting units and stop the en- gine. Remove the key from the ignition switch.

CAUTION

Operate all hydraulic controls to relieve system pressure and avoid injury from pressurized hydraulic oil.

2.Remove wheel and brake assembly from unit (see Repair section of Chapter 6 ± Wheels and Brakes).

3.Clean wheel motor (1) and hydraulic connections. Label all tube hose connections for reassembly pur- poses. Put caps or plugs on any hydraulic lines or fittings left open or exposed.

4.Disconnect tube connections (2 and 3) from hydrau- lic fittings (5 and 6). On the left±hand wheel motor, also disconnect hose connection (4) from hydraulic fitting (7). Allow hydraulic oil to drain from tubes and hose into a suitable container.

5.Support wheel motor (1). Remove four cap screws

(10) and lock nuts (11) from support frame (12). Remove brake bracket (13), grass shield (14), and spacers (15). Pull wheel motor from the support frame.

6.Remove hydraulic fittings (5 and 6) and O±ring from the wheel motor (1). On the left±hand wheel motor, also remove hydraulic fitting (7) from the wheel motor.

Front Wheel Installation (Fig. 30)

1.Place and support wheel motor (1) into the support frame (12). Insert four cap screws (10) through the sup- port frame and wheel motor.

2.Slide spacers (15), grass shield (14), and brake bracket (13) onto the cap screws (10) and wheel motor

(1). Tighten lock nuts (11) onto cap screws.

3.Install hydraulic fittings (5 and 6) onto the wheel mo- tor (1). On the left±hand wheel motor, also install hy- draulic fitting (7) onto the wheel motor. Tighten hydraulic fittings.

				9 (LH)
	4			7 (LH)
	3
				17 (LH)
			8	6
				16
			5
				1
10			16
				14
		2
	12
			15
				13
				11

Figure 30

1.	Wheel motor	10.	Cap screw
2.	Tube connection	11.	Lock nut
3.	Tube connection	12.	Support frame
4.	Hose connection	13.	Brake bracket
5.	Hydraulic fitting	14.	Grass shield
6.	Hydraulic fitting	15.	Spacer
7.	Hydraulic fitting	16.	O±ring
8.	O±ring	17.	O±ring

9.O±ring

4.Install tube connections (2 and 3) to hydraulic fit- tings (5 and 6). On the left±hand motor, also ins hose connection (4) to hydraulic fitting (7). Tighten connec- tions.

5.Install wheel and brake to unit (see Repair section of Chapter 6 ± Wheels and Brakes).

Hydraulic System Page 4 ± 44 Reelmaster 2300±D/2600±D