Toro 2300-D, 2600D Roller Bearing and Seal Replacement, Remove Seals and Bearings, Cutting Units

Roller Bearing and Seal Replacement

1	5	7	9	2	4	3
		8
			4
					3
	2				6
					5
			9
						1
				8
				7

Figure 25

1.	Adjustment nut	4.	Full roller	7.	Bearing cone
2.	Roller shaft	5.	Outer seal	8.	Bearing cup
3.	Grease fitting	6.	Shim washer	9.	Inner seal

Note: A rear (full) roller is shown. Bearing and seal configurations are the same for full and wiehle rollers. The wiehle roller does not have the a inner seal and shim washer. The shim washer is not used on all full roll- ers.

Remove Seals and Bearings

1.Clean inside roller around both adjusting nuts and roller shaft ends. Both areas should be free of dirt and debris.

2.Remove an adjusting nut from one end of the roller shaft.

3.Keep roller level and slide the shaft with the remain- ing adjusting nut out of the roller.

4.If disassembling a full roller, pour the oil from inside the roller into a suitable container.

5.Secure roller in a vise.

6.Remove outer seals and shim washers (if installed).

7.Remove both bearing cones

Note: An electric arc welder can be used to shrink the bearing cup to simplify its removal. Only a small arc in one location on the cup is required.

8.Remove both bearing cups from the roller. Remove both inner seals (if installed).

9.Discard seals and bearings.

Cutting Units Page 7 ± 20 Reelmaster 2300±D/2600±D