Rear Lift Cylinder
| 13 | |
| 12 | |
11 | 14 | |
| ||
14 |
| |
ROD CLEVIS |
| |
10 |
| |
15 |
| |
4 | 9 | |
3 |
| |
5 | 15 | |
| 5 | |
2 | 6 | |
1 | ||
| ||
| 7 | |
| 8 |
Figure 63
Hydraulic System
1. | Hose connection | 6. | Cap screw |
2. | Hose connection | 7. | Ram pivot pin |
3. | Hydraulic fitting | 8. | Pivot support |
4. | Hydraulic fitting | 9. | Lift pivot shaft |
5. | O±ring | 10. | Lift cylinder |
Removal (Fig. 63)
1.Before removing any parts from the hydraulic man- ifold, park the machine on a level surface, engage the parking brake, lower the cutting units and stop the en- gine. Remove the key from the ignition switch.
CAUTION
Operate all hydraulic controls to relieve system pressure and avoid injury from pressurized hydraulic oil.
11.Cotter pin
12.Clevis pin
13.Lift arm
14.Flat washer
15.O±ring
CAUTION
The rear lift cylinder is located near the muffler exhaust pipe. To avoid possible burns, allow the exhaust pipe to cool be- fore working on the rear lift cylinder. 
2.Label all connections for reassembly. Disconnect hose connections (1 and 2) from hydraulic fittings (3 and 4). Allow hoses to drain into a suitable container.
Reelmaster 2300±D/2600±D | Page 4 ± 71 | Hydraulic System |
