'HOO(S&RORU0RQLWRU4XLFN6HWXS*XLGH
6DIHW\,QVWUXFWLRQV
Observe the following safety guidelines when connecting and using your monitor:
Be sure your monitor is electrically rated to operate with the AC power available in your loca ti on.
Locate your monitor near an easily accessible electrical ou tl et .
Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or touc hed with
a sharp or abrasive implement.
Put your monitor in a location with low humidity and a minimum of dust.
Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the power cable, and ke ep the
cable away from where people could trip over i t.
Never insert anything metallic into the monitor openings. Doing so may create the dange r of el ec tric shock.
To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the monitor’s case.
Be sure to hold the plug, not the cable, when d isconnecting the monitor from an electrical outlet.
Openings in the monitor cabinet are provided for ventilation. To prevent over heating, these openings should not be blocked or
covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface. Doing so may block the ventilation openings
in the bottom of the cabinet. If you put the monitor in a bookcase or some other enclosed space, be sure to provi de ade quate
ventilation.
Do not expose the monitor to rain or use it near water. If the monitor acci dentally gets wet, unplug it and contact an authorized
dealer immediately. You can cle an the exte rior of the mon itor with a damp clo th when n ecessary , but be su re to un plug the mon-
itor first.
If your monitor does not operate normally—in particular, if there are any unusual sounds or smells comin g from it—unplug the
monitor immediately and contact an authorized dealer or service center.
&RQQHFWLQJ<RXU0RQLWRUWRD&RPSXWHU
1. Turn off your computer and unplug your computer’s power cable.
2. Connect the blue connector of the monitor's signal cable to the blue vid eo connector on the back of your computer. Tighten the
connector screws finger-tight. Do not overtighten.
3. Fully insert the monitor power cable into the power port on the back of the monitor.
4. Plug the power cables of your computer and your monitor into a nearby electrical outlet.
5. Turn on your computer and monitor. If the monitor does not display an image, refer to the troubleshoo ting section of this
guide.
VIDEO IN
POWER
2
3
4