Dell M1000E manual Dell PowerConnect-KR 8024-k Switch

3Select the Setup tab. The Configuring I/O Modules Network Settings page is displayed.

4Configure the switch for integration into your network.

–Select DHCP Mode Enabled if your network uses a DHCP server to assign IP addresses.

–If your network uses static IP addressing, enter an IP address, subnet mask and gateway.

5When you have finished, click Apply.

6Click the Deploy sub-tab.

After all I/O modules have been configured and connected, the enclosure’s blades can be inserted and booted with full network communication.

Dell PowerConnect-KR 8024-k Switch

The PowerConnect M8024-k switch provides 16 internal 10 GbE ports, four external 10 GbE SFP+ ports, and one 10 GbE expansion slot for 10 GbE external uplinks. The expansion slot on the front panel can support:

•A 10 Gb Ethernet module with four optical SFP+ connectors

•A 10 Gb Ethernet module with three copper CX4 uplinks

•A 10 Gb Ethernet module with two copper 10GBASE-T uplinks This module is hot-swappable and may be installed in Fabric A, B, or C.

Configuring the I/O Modules

53