Before You Begin
Network Information
You can configure your I/O switch modules using:
•The CMC (see "Configuring a Switch Module Network Ethernet Port Using the
NOTE: The default IP address for the CMC is 192.168.0.120.
•The CMC CLI using serial console redirection.
•Direct access to the I/O module’s serial port (if supported).
•The I/O module’s default IP address (if supported).
Switch Modules
Configuring a Switch Module Network Ethernet Port Using the
You can use the CMC
NOTE: Use this procedure to configure the switch’s
NOTE: To change settings on the I/O module configuration page, you must have Fabric Administrator privileges for the particular Fabric in which the module is installed.
NOTE: The network IP address set on the I/O module by the CMC is not saved to a configuration file. To save the IP address configuration permanently, use the connect
NOTE: Do not attempt to configure I/O module network settings for Ethernet pass- through or Infiniband switches.
1Log in to the CMC’s
2Select I/O Modules in the Chassis menu in the system tree.
52
Configuring the I/O Modules