Dell M4001F, M4001Q

Rev 1.0

Mellanox Technologies

This symbol indicates information that is helpful to the user.

This symbol indicates a situation that can potentially cause damage to hardware or

software.

BEWARE! This symbol indicates a situation that can potentially cause personal injury

or damage to hardware or software.

Contents

Main Document Number: 3513 Contents Page About this Manual Intended Audience Related Documentation Online Resources Conventions Page 1Overview 1.1 InfiniBand Connectors 1.2 Switch Status Lights 1.3 I2C Interface RJ-45 Connector 2Installation and Basic Operation 2.1 Installation Safety Warnings Page 2.2 Mechanical Installation 2.2.1 Removing an Old Switch From the Chassis 2.2.2 Removing an I/O Module Blank From the Chassis 2.2.3 Installing the Mellanox M4001[F, Q] Switch Into the Dell Chassis 2.3 Power Connections and Initial Power On 2.4 InfiniBand Cable Installation Page 3Cluster Management and Firmware 3.1 Network Management and Clustering Software 3.2 Updating Firmware 3.2.1 Instructions for Reprogramming Over the InfiniBand Network 4 Troubleshooting Appendix A: Specifications Table 4 - M4001[F, Q] Specification Data Physical Power and Environmental Protocol Support Regulatory Compliance Page Page Appendix B.1: FCC Statements (USA) B.1.4 MIC Certification (Korea) Appendix C: QSFP Interface Table 5 - InfiniBand QSFP Connector Pinout Figure 6: Pinout Looking Into the Rear of the Connector and the Front of the Cage Appendix D: Avertissements de scurit dinstallation Page Appendix E: Installation - Sicherheitshinweise