Dell M70 manual Display Bezel

1	display
2	pull-tab
3	display cable connector
4	antenna cable
5	computer base
6	system board connector
	for display cable

Display Bezel

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the display assembly.

3.Use a plastic scribe to pry the six round display bumpers out of the screw holes located on the front of the bezel. Do not remove the oval bumpers.

4.Remove the six M2.5 x 5-mm screws located on the front of the bezel under the bumpers.

NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.

5.Separate the bezel from the top cover by lifting the inside edge of the bezel away from the top cover.

NOTE: You may need to use a plastic scribe to begin the separation.

Pull the bezel from the top edge toward the center of the panel to open the snaps. Push the bezel on the sides and bottom away from the center of the panel to open the snaps.

NOTICE: To avoid damaging the bezel, start pulling the bezel up near the bottom of the display (near the DELL™ logo) and work around the display and toward the latch release.