To remove SFP modules:
1Remove the FC cable from the SFP module. See "Installing and Removing Fibre Channel Cables" on page 36.
NOTE: To avoid damaging the cable or the SFP module, disconnect the FC cable before removing the SFP module.
2Unlock the SFP module latch. For SFP modules that contain wire tabs, unlock the SFP module latch by pulling the wire latch outward 90°.
3With the SFP module latch in the unlocked position, remove the SFP module. For SFP modules that contain wire tabs, grasp the wire latch and pull the SFP module out of the port.
4Replace the protective cap on the SFP module and the host port.
5Place the SFP module into a
Guidelines for Using Fiber Optic Cables
•Do not route the cable along a folding cable management arm.
•For devices on slide rails, leave enough slack in the cables so they do not bend to a diameter of less than 76 mm (3"), or a radius less than 38 mm (1.5"), when extended or become pinched when retracted.
•Route the cable away from places where it can be damaged by other devices in the rack cabinet.
•Do not use plastic cable ties in place of the provided cable straps.
•Do not
•Do not place excess weight on the cable at the connection point. Ensure that the cable is well supported.
35