C A C H E D I S A B L E D D U E T O F A I L U R E — The primary cache internal to the microprocessor has failed. Contact Dell. See "Contacting Dell" on page 141.
CD D R I V E C O N T R O L L E R F A I L U R E — The CD drive does not respond to commands from the computer. See "Drive Problems" on page 89.
D A T A E R R O R — The hard drive cannot read the data. See "Drive Problems" on page 89.
D E C R E A S I N G A V A I L A B L E M E M O R Y — One or more memory modules may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them. See "Memory" on page 119.
D I S K C: F A I L E D I N I T I A L I Z A T I O N — The hard drive failed initialization. Run the hard drive tests in the Dell Diagnostics. See "Dell Diagnostics" on page 85.
D R I V E N O T R E A D Y — The operation requires a hard drive in the bay before it can continue. Install a hard drive in the hard drive bay. See "Hard Drive" on page 116.
E R R O R R E A D I N G PCMCIA C A R D — The computer cannot identify the ExpressCard. Reinsert the card or try another card. See "ExpressCards" on page 71.
E X T E N D E D M E M O R Y S I Z E H A S C H A N G E D — The amount of memory recorded in NVRAM does not match the memory installed in the computer. Restart the computer. If the error appears again, contact Dell. See "Contacting Dell" on page 141.
T H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E — The file that you are trying to copy is
too large to fit on the disk, or the disk is too full. Try copying the file to a different disk or use a larger capacity disk.
AF I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S : \ / : * ? “ < > — Do not use these
characters in filenames.
G A T E A20 F A I L U R E — A memory module may be loose. Reinstall the memory modules and, if necessary, replace them. See "Memory" on page 119.
G E N E R A L F A I L U R E — The operating system is unable to carry out the command. The message is usually followed by specific
H A R D - D I S K D R I V E C O N F I G U R A T I O N E R R O R — The computer cannot identify the drive type. Shut down the computer, remove the hard drive (see "Hard Drive" on page 116), and boot the computer from a CD. Then shut down the computer, reinstall the hard drive, and restart the computer. Run the
H A R D - D I S K D R I V E C O N T R O L L E R F A I L U R E 0 — The hard drive does not respond to commands from the computer. Shut down the computer, remove the hard drive (see "Hard Drive" on page 116), and boot the computer from a CD. Then shut down the computer, reinstall the hard drive, and restart the computer. If the problem persists, try another drive. Run the
H A R D - D I S K D R I V E F A I L U R E — The hard drive does not respond to commands from the computer. Shut down the computer, remove the hard drive (see "Hard Drive" on page 116), and boot the computer from a CD. Then shut down the computer, reinstall the hard drive, and restart the computer. If the problem persists, try another drive. Run the
92
