w w w . d e l l . c o m s u p p o r t . d e l l . c o m
CAUTION: Safety Instructions
Use the following safety guidelines to help ensure your own personal safety and to help protect your projector and working environment from potential damage.
CAUTION: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards, and/or mechanical hazards.
CAUTION: SAFETY: General
•Be careful when handling the projector, as the projector and the surface beneath it may become hot with use.
•The lamp becomes very hot with use. Let the projector cool for at least 30 minutes before removing the lamp.
•If you are replacing a lamp, follow the instructions in the Owner’s Manual and the documentation that came with the lamp replacement kit.
•Do not touch any part of the lamp. Projector lamps are very fragile and may shatter if touched.
•Remove the lens cap before turning on the projector. Failure to do so may cause the lens cap to reach high temperatures.
•To avoid damaging the projector and lamp, allow the cooling fan to run for two minutes before turning off the projector.
•Do not block the ventilation slots and openings on the projector.
•Disconnect the power cord from the electrical outlet if the projector is not being used for a long period of time.
•Do not use the projector in an extremely hot, cold, or humid environment.
•Do not use the projector in areas susceptible to excessive dust and dirt.
•Do not use the projector near any appliance that generates a strong magnetic field.
•Do not place the projector in direct sunlight.
•Do not look into the lens while the projector is on; the bright light may hurt your eyes.
•To reduce the risk of fire or electric shock, do not expose the projector to rain or moisture.
•To prevent electric shock, do not open or disassemble the projector further than what is needed for lamp replacement.
28
