that the hole marked by the B arrow is not plugged.
•Once clean, all the parts must be
If this cleaning is not carried out after every use, the milk foamer may not work properly, the milk may not be aspirated or the milk may drip from the milk tank tube.
CLEANING THE FILTER HOLDER FOR PODS
Every so often, the filter holder for pods should be cleaned, as follows:
•press the filter holder button and remove the filter, as indicated in fig. 25.
•check that the pinholes of the filter are not plugged. If necessary, clean it carefully with hot water, scrubbing it with an abrasive pad.
•clean the inside of the filter holder and the rubber gasket;
•replace the filter.
Never wash the filter holder in the dishwasher.
CLEANING THE ESPRESSO BOILER OUTLET
At least once a year, it is necessary to clean the outlet of the espresso boiler in the following manner:
•check that the coffee machine is not warm and the plug is detached from the mains;
•using a screwdriver, unscrew the screw that holds the outlet of the espresso boiler (fig. 23);
•using a moist cloth, clean the area of the boiler where the outlet was positioned;
•brush the outlet with a little dish washing liquid until all the pinholes are clean;
•rinse the outlet under the tap, still scrubbing it;
•replace the outlet of the espresso boiler.
OTHER CLEANING OPERATIONS
1.Do not use solvents or detergents in cleaning the coffee maker. It is enough to use a soft, moist cloth.
2.Extract the
3.Clean the water tank for espresso coffee.
4.Never immerse the coffee maker in water, not even when cleaning it. It is an electrical appliance.
DECALCIFICATION
It is advisable to clean the calcium from the machine every 200 cups of coffee. It is recommended that specific
1.Fill the tank with water using 1 liter of water;
2.Dissolve 2 spoonfuls (about 30 grams) of citric acid in the water (citric acid may be found in a pharmacy);
3.Press the ESPRESSO switch and wait until the ‘OK’ pilot light comes on;
4.Check that the filter holder is not attached and place a container under the outlet of the machine;
5.Press the coffee delivery switch and allow half the water in the tank to flow out. Then stop the flow by pressing the switch again;
6.Allow the solution to act for about 15 minutes, then start up the flow again until the tank is completely empty;
7.To eliminate the remains of the solution and of the calcium, rinse the tank well, fill it with clean water and replace it in its seat. Press the coffee delivery switch;
8.Wait until the tank is empty;
9.Press the switch again and repeat operations 7 and
8 one more time.
Repairs for malfunctioning caused by problems of calcium
10