Read this instructions manual carefully before installing and using the device. Only by doing so will you be able to obtain the best results and the maximum safety of use.
DESCRIPTION OF THE DEVICE
The terminology below will be used throughout the pages that follow.
1.Filter holder for ground coffee
2.Filter holder for prefilled espresso pods (if fitted)
3.Steam boiler cap
4.Lid of milk tank
5.Frother
6.Mixer
7.Milk tank
8.Coffee measuring spoon
9.
10.Espresso delivery switch
11.Espresso on/off switch ( 
)
12. Steam boiler ‘ON’ pilot light
13.‘OK’ pilot light for cappuccino coffee
14.Steam boiler on/off switch ( 
)
15.Pilot light - espresso boiler on
16.‘OK’ pilot light for espresso coffee
17.
18.Tamper
19.Espresso boiler outlet
20.Removable water level window in tank for espresso coffee
21.Water tank for espresso coffee
22.Lid of water tank for espresso coffee
23.Steam boiler
24.Steam knob
25.
26.
27.Shelf for cups
28.Water measuring container for steam boiler
29.Absortion water sponge
30.
31.
INSTALLATION
•Place the coffee maker on a work surface at a safe distance from taps and sinks.
•Check that the mains voltage corresponds to the voltage indicated on the coffee maker’s information plaque. Only connect the device to an outlet that has a minimum delivery of 10 A and is fitted with the required ground. The manufacturer will not be held responsible for any accidents that may occur due to
the lack of grounding of the unit.
•In the event of incompatibility between the outlet and the plug of the coffee maker, have the plug replaced by a qualified electrician.
•Never install the machine in an environment that can reach a temperature less than or equal to 0°C (if the water in it freezes, the coffee maker may be damaged).
HOW TO MAKE ESPRESSO COFFEE
FILLING THE WATER TANK
Lift the lid and take out the water tank (fig. 1). Fill the tank with fresh, clean water (fig. 2). Place the tank back in its position, pressing it lightly so as to open the valve located on the bottom of the tank itself.
It is recommended that the tank be filled when the machine is cold. In the event of it being necessary to fill it when the machine is warm, it is most likely that while the tank is out, some water will collect in its seat. It is necessary to dry this water using the sponge, which is to be found on the bottom of the tank itself (fig. 3).
More simply, the tank can be filled without extracting it, by pouring water directly into it from a carafe.
NOTE: never operate the coffee maker without water in the tank.
The quantity of water contained in the tank may be checked by looking into the tank through the window. This allows you to add water when necessary.
PREHEATING THE COFFEE UNIT
In order to obtain coffee at the right temperature, it is suggest to preheat the machine. The best way to accomplish this is by pressing the 
ESPRESSO switch (fig. 4) at least half an hour before making the coffee. During this time, it is necessary to leave the filter holder attached to the machine. To attach the filter holder, position it under the boiler outlet with the handle towards the left (see fig. 5); push upwards and at the same time rotate the handle towards the right; always rotate as far as it will go. After a half hour, the coffee can then be made as described in the next section.
Alternatively, it is possible to carry out the preheating quickly by following these steps:
1.Turn on the machine by pressing the 
ESPRESSO switch (fig. 4).
2.Place a cup under the boiler outlet and make sure that the filter holder is attached to the machine. Use the same cup in wich the coffee will be served in, so that it may be preheated.
3.Wait until the “ESPRESSO OK” pilot light turns on
7
