APPLIANCE DESCRIPTION
(See drawing on page 3)
The following terminology and letters of reference will be used continuously in the following pages:
A.Boiler
B.Cap
C.Steam knob
D.Milk tank lid
E.Milk tank
F.Supply cable
G.Drip tank
H.Cup adaptor
I.Carafe with lid
L.Filter holder
M.Filter
N.Measuring spoon
O.Selector for STRONG, MEDIUM or LIGHT coffee and CAPPUCCINO
P.Switch light
Q."OK steam ready" pilot light
R.Emulsifier
S.Antisplash hood.
PREPARING THE COFFEE
1.Unscrew the boiler cap (B), turning it in an anti- clockwise direction.
2.Using the carafe (l) supplied (fig. 1), pour the water in the boiler (fig. 2) respecting the quanti- ties shown in the table at the end of the text. Do not exceed the quantities shown or the applian- ce will cease to work properly. The filling of the boiler must be carried out with the switch light (P) off.
3.Close the boiler cap carefully by turning it in a clockwise direction.
4.Insert the filter in the filter holder (fig. 3).
5.Using the measuring spoon (N), pour the coffee into the filter, respecting the amounts shown in the table at the end of the text, and spread it evenly (fig. 4). Use
6.Remove any excess coffee from the edge of the fil- ter (fig. 5).
7.To attach the filter holder to the machine, bring the filter holder under the boiler shower (fig. 6), ali- gning its handle with the arrow marked on the lid of the machine (fig. 7). Next, push the filter holder up and at the same time turn it completely to the
right. It is of no importance if the handle of the fil- ter holder is not centred in relation to the machi- ne; it is, however, important for the filter holder to be situated firmly in its housing.
8.The carafe with lid must be positioned under the filter holder in such a way that the spout of the fil- ter holder is inside the opening contained on the lid (fig. 8).
9.Set the selector (O) to the type of coffee required:
"1 LIGHT" for a weak coffee, "2 MEDIUM" for a normal coffee, "3 STRONG" for a strong coffee (fig. 9).
10.Check that the steam knob (C) is turned off firmly and press the switch light. The pilot light will come on (fig. 10).
11.It takes approx. 3 minutes for the coffee to start to come out. After it has been emitted, turn off the switch light.
WARNING: In order to avoid puffs of steam, you must always eliminate the residual steam inside the boiler by turning the steam knob to let out all the steam before removing the filter holder (fig. 11).
NOTE: For safety reasons, it is not possible to open the boiler cap when the boiler is hot as the cap turns without unscrewing. If it has to be remo- ved for any reason, it is always necessary to let off steam from the boiler using the steam knob as
described immediately above.
12.In order to eliminate the coffee grounds from the filter holder, turn it upside down and beat it repeatedly so that the grounds come out (fig. 12). Alternatively, rinse the filter holder and the filter itself under running water.
WARNING: To eliminate the "new" smell the first time the appliance is used, complete the coffee cycle a few times without using the coffee pow- der.
ADAPTOR ASSEMBLY
The adaptor (H) must be used every time the coffee is required to be made directly in the cup. For it to be assembled, it only needs to be inserted in the lower part of the filter holder (fig. 13).
PREPARING CUPPUCCINOS
1.Pour the amount of milk shown in the table at the end of the text into the carafe before pouring it into the milk tank (E). Never exceed the MAX level marked on the tank (fig. 15), otherwise the machi- ne could continue to drip milk from the tank pipe
7
