DeLonghi DEDW654FI manual Using Your Dishwasher, Turning Onthe Appliance, Changethe Program, Page

Models: DEDW654FI

1 16
Download 16 pages 55.19 Kb
Page 9
Image 9
Using Your Dishwasher

Using Your Dishwasher

Installation

TURNING ONTHE APPLIANCE

Starting a wash cycle:

1.Draw out the lower and upper basket, load the dishes and push them back. It is recommended to load the lower basket first, then the upper one (see the section entitled “Loading the Dishwasher”).

2.Pour in the detergent (see Page 17).

3.Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.

4.Close the door, press the ON/OFF button to switch on the machine.

5.Press the menu Button, then press ‘-’ or ‘+’ button to change the program as follows:

Auto->Intensive->Heavy->Normal->Glass->60 Min->Rapid->Soak;

If a program is selected, the display screen will show. Press the OK button, Close the door, the dishwasher will start.

CHANGETHE PROGRAM

Premise:

1.A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been released, and the appliance may have already drained the wash water.

If this is the case, the detergent dispenser must be refilled (see the section entitled "Adding Detergent to Dishwasher").

2.Open the door, press the Menu button, then press ‘+’ or ‘-’ button, you can change the program to the desired cycle setting (see the section entitled “Starting a washing program" ).

NOTE: If you open the door during a wash cycle , the machine will pause. The program light will stop blinking and the buzzer will sound every minute until you close the door. After you close the door, the machine will keep on working after 10 seconds.

FORGETTO ADD A DISH?

A forgotten dish can be added at any time before the detergent cup opens.

1.Open the door a little to stop the washing.

2.After the spray arms stop working, you can open the door completely.

3.Load the forgotten dishes.

4.Close the door.

5.The dishwasher will start running again after 10 seconds.

WARNING! It is dangerous to open the door when washing, because the hot water may scald you.

ATTHE END OFTHEWASH CYCLE

When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then the dishwasher will automatically go to off-mode after the end of the programme. (If you opened the door during the sound, you must press the on/off button to turn it off). Then shut off the water supply and open the door of the dishwasher. Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.

Switch off the Dishwasher

1.The buzzer of the dishwasher will sound for 8 seconds, then automatically go to off-mode.

2.Turn off the water tap.

Open the door carefully

Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around 15 minutes before removing from the appliance.

Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. Dishes will be cooler and the drying will be improved.

Unloading the Dishwasher

It is normal that the dishwasher is wet inside.

Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto the dishes in the lower one.

ŸInstall the hook on the aesthetic panel and put the hook into the slot of the outer door of dishwasher (see below).

ŸAfter positioning the panel, fix it to the door using the screws supplied. Remove the four short screws and screw in the four long screws.

Remove the 4 short screws

Screw in the

4 long screws

Tension adjustment of the door

ŸThe door springs are set at the factory to the proper tension for the outer door. If an aesthetic fascia panel is installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable (see below).

ŸAdjust the door spring tension until the door remains horizontal and balanced in the fully- opened position, yet rises to a close with the slight lift of a finger.

Page 24

Page 9

Page 9
Image 9
DeLonghi DEDW654FI Using Your Dishwasher, Turning Onthe Appliance, Changethe Program, Forgetto Add A Dish?, Installation