FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 30 to 40 mm thick.
The kit includes four “F” brackets and four
■■ Cut the unit according to the dimensions in fig. 1.
■■ Turn the hob upside down and rest the glass side on a soft surface.
■■ Spread the seal “G” around the edge of the hob (fig. 5).
■■ Fasten the brackets “F” to the appropriate socket holes, without tightening the screws “S” for the moment. Make sure that the tabs are mounted correctly, as shown. Rotate the tabs so that the cooktop can be put into the cutout.
■■ Put the cooktop into the cutout and position it correctly.
■■ Put the brackets “F” into place; tooth “A” of the brackets should go into the hole (fig. 6).
■■ Tighten screws “S” until the cooktop is completely secured to the bench.
■■ Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop. Take care not to damage the workbench.
Figure 5
| G |
G | Adhesive side |
Figure 6
| A | 3 cm | 4 cm |
|
|
| |
253 cmmm min | S | F |
|
|
|
| 9 |
