DeLonghi EAM4500 manual HOT Water Program Quantity, Cappuccinoorlatte

11 CHANGING THE QUANTITY OF HOT WATER

The appliance is factory preset to automatically deliver 8.5 oz of hot water.

To change these quantities, proceed as follows:

•Attach the water spout (fig. 4).

•Position a container under the spout (fig. 3).

•Press the button for at least 8 seconds then release. The appliance displays:

HOT WATER PROGRAM QUANTITY

and hot water is delivered from the water spout.

•When the hot water in the cup reaches the required level, press the button to memorize the new amount. (You should not run off hot water for more than two minutes at a time).

12 PREPARING LATTE OR CAPPUCCINOS (MILK WITH COFFEE )

• Select the taste of the coffee you want to use to make the cappuccino by pressing the button.

•Remove the frothed milk lid from the milk container.

•Fill the container with about 3.5 ounces of milk for each cappuccino to be prepared (fig. 19). Never exceed the MAX level (corresponding to about 25 oz) marked on the container. You are recommend- ed milk at refrigerator temperature (about 41°F/5° C).

•Make sure the milk intake tube is correctly inserted in the rubber washer (fig. 20), then put the lid on the milk container.

•Remove the hot water spout (fig. 21) and attach the milk container to the nozzle making sure the arrow on the container lid is lined up with the arrow on the control panel of the appliance (fig. 22).

•Position the milk tube as shown in fig. 23 and then place a sufficiently large cup under the coffee and milk spouts.

•If you want to make caffelatte (hot milk + coffee), put the froth regulator on CAFFELATTE.

•If you want to make cappuccino (frothed milk + coffee) using whole milk, put the froth regulator on CAP-

PUCCINO.

•If you want to make cappuccino (frothed milk + coffee) using non-fat milk, put the froth regulator on CAP-

PUCCINO NON FAT.

NOTE: you can put the milk froth regulator in-between the two positions for personalize the quantity of the milk froth.

• Press the button (fig. 24). The appliance displays:

cappuccinoorlatte

and after a few seconds, the frothed milk is delivered from the milk spout into the cup below. (Delivery stops automatically).

•The appliance then grinds the beans, delivers the coffee and displays the "ready" message again.

•The cappuccino is ready. Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder.

NOTE 1: While preparing the cappuccino, milk or coffee delivery can be interrupted by pressing button .

NOTE 2: If you run out of milk while delivering the milk, remove the container and refill it. Then put it back

in place and press the button to request a cappuccino again.

NOTE 3: To ensure the milk frother is absolutely clean and hygienic, after making cappuccinos, clean the channels inside the milk container lid:

•Place a cup under the milk spout;

•Press the CLEAN button on the frothed milk container lid down and hold down for at least 8 seconds. The appliance displays:

14