Auto-start
You can set the
Please note!
To activate this function, the time must already have been set correctly.
To activate
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 8) until “Auto- start” is displayed;
3.Press the button. “Activate?” is displa-
yed;
4.Press the button to confirm;
5.Turn the selection knob to choose the hours;
6. Press the | button to confirm; |
7.Turn the selection knob (fig. 8) to change the minutes;
8.Press the button to confirm;
9.Press the button to exit the menu. Once the time has been confirmed, activation of
To deactivate the function:
1.Select
2.Press the button. “Deactivate?” is di- splayed;
3. | press the |
| button to confirm. | ||
The | symbol |
|
|
| is no longer displayed. |
|
|
Setting the temperature
To modify the temperature (low, medium, high) of the water used to make the coffee, proceed as follows:
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 8) until “Set temperature” is displayed;
3.Press the button;
4.Turn the selection knob until the required temperature (high, medium, low) is displa- yed;
5. Press the | button to confirm; |
6. Press the button to exit the menu.
Energy Saving
Use this function to activate or deactivate energy saving mode.
This mode is active by default, reducing energy consumption in compliance with current Europe- an regulations.
When energy saving mode is active, an asterisk appears below “Energy Saving” in the menu.
To deactivate “energy saving” mode, proceed as follows:
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 8) until “Energy Saving” is displayed;
3. Press the | button. “Deactivate?” is di- | ||
splayed; |
|
|
|
|
|
4.Press the button to deactivate energy saving mode;
5.Then press the button to exit the menu.
When the function is active, if the machine is not used for about 1 minute, “Energy Saving” is di- splayed.
Please note!
When in energy saving mode, a few seconds may elapse before the first coffee is delivered as the appliance must heat up again.
Setting water hardness
For instructions on setting water hardness, see page 19.
Setting the language
To change the language for the display, proceed as follows:
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 8) until “Set lan- guage” is displayed;
3.Press the button;
4.Turn the selection knob until the required language is displayed;
5. | Press the | button to confirm; |
6. | Press the | button to exit the menu. |
Install filter
For instructions on how to install the filter, see the section “Installing the filter” on page 19.
Replacing the filter
For instructions on how to replace the filter, see the section “Replacing the filter” on page 20.
11