DeLonghi PAC160 O p e r a t i o n, English, Switching The Appliance On, Air-Conditioningfunction

pac160 GB 25-01-2003 10:19 Pagina 11

O p e r a t i o n

SWITCHING THE APPLIANCE ON

Connect the appliance to the mains supply.

On the display two lines will appear indicating Stand-by mode Press the ON/OFF button (A) and then the MODE button until the relevant function indicator appears viz.:

Indicator C : air-conditioning

Indicator D : dehumidifying

Indicator E : ventilation

AIR-CONDITIONING FUNCTION

This function is ideal in hot, humid weather conditions when the atmosphere requires to be cooled and dehumidified.

To ensure proper function of the appliance, after selecting the air- conditioning function, press buttons + (F) or – (G) until the desired temperature appears on the display.

The temperatures most suited to the atmosphere in summer vary

between (24-27°C) 75°-80°F. We do not advise selection of tem-77 peratures much lower than those outside.

Select fan speed by pressing the “FAN” button (Q) until the fan speed indicator appears:

MAX (P): if you want the maximum power of the air-conditioner to reach the desired temperature as quickly as possible.

MIN (O): if you want to reduce the level of noise and still maintain a good level of comfort.

SILENT (N):when minimum noise is required,

AUTO (M):if you prefer the appliance to select the fan speed for the temperature selected on the display panel.

DEHUMIDIFYING FUNCTION

This function is ideal for reducing humidity in the atmosphere while avoiding increases or decreases in temperature (in between sea- sons, damp places, wet spells of weather).

When you select the dehumidifying function, the letters “ ” will appear on the display.

The water is collected in the tank at the rear of the appliance. When the tank is full, the appliance will stop working and the display will show the letters “ ” (Full Tank); the tank must then be emptied. When it is re-inserted, the appliance will re-start auto- matically. N.B. remove the air exhaust hose (14).

In the air-conditioning function, the unit employs an exclusive con- densation recycling system to dispose of excess moisture. In normal conditions, condensation is disposed of automatically. When the humidity is particularly high, an excess of condensation may built up in the TANK 9 . When this happens, the display will show the letters “ “ (Full Tank); indicating that the TANK should be emptied. Whe- never conditions of high humidity make the problem recurrent, you may discharge the excess water directly into a drain, using the rub- ber tube supplied. The tube should be inserted into the hole provi- ded, after having removed the rubber stopper. (see figure).

Make sure the TANK is put back correctly otherwise the display will

continue to show the letters “ ”

ENGLISH

11