INSTRUCTIONS FOR USE 4. USE OF THERMOSTAT
Turn thermostat clockwise to the maximum position. Switch on both switches. The lights on the switches remain on inde- pendently from of the cycling of the thermostat. When the room reaches the desired temperature, turn the thermostat knob anticlockwise very slowly and carefully until you hear a “click”. This will automatically set your unit to cycle on and off at that desired heat setting. (For timer instructions, see point 5).
Frost prevention mode (anti-freeze setting)
Turn the thermostat dial to the 
position and press the switches. The appliance will maintain a minimum room tempe- rature of approximately 5°C (41 F) thus preventing freezing conditions with a minimum energy consumption.
REMINDER
To completely shut unit off, ON/OFF switches must be in OFF position.
5.HOW TO USE THE 24 PROGRAMMABLE CLOCK TIMER Please refer to the illustration below:
Operating time
Notches
Tab
Pointer
IMPORTANT: There are 96 notches around the dial. Each notch represents a 1/4 hour (15 minutes). Your appliance can be programmed to switch itself ON and OFF at the time you want. With the timer you can approximate your settings to within 15 minutes and program up to 48 cycles (1 cycle = 1 “ON” + 1 “OFF”) over a period of 24 hours (12 hours a.m.+12 hours p.m.).
The notches can be pushed inwards or pulled outwards by merely using your finger tips. When the notch is in the inward position (towards the center of the dial), the heater will operate during that 15 minute period. If the notch is in the out- ward position, the heater will not operate during this period. If you want to bypass the timer, all notches must be pushed inward.
Clock setting
The program/timer, as with all clocks, must be set to the correct time. If for example the time is 21.30 (9.30 p.m.) (day zone), rotate the dial clockwise (following the direction of the arrow) until 21.30 (9.30 p.m.) is aligned with the triangular pointer.
IMPORTANT:
DO NOT ROTATE CLOCK DIAL
The timer is in effect an electric clock and would only work while it is plugged into a power supply. When unplugged, the timer stops and must be later
Timer operation
a)Plug in the heater.
b)Turn timer dial clockwise to set clock with the current time of day (see above “Clock setting”).
4
